Uniden BC250D Technické informace stáhnout pdf (Strana 19)

Uniden Control Tab:

This tab allows you to enable control

of a Uniden scanner. Since 9600

baud APCO-P25 systems are 100%

digital, only the Uniden BC250D,

BC296D, and the BC796D scanners

with digital cards installed are

supported. The program may control

other Uniden scanners as well, but the

value will be minimal at best.

To enable control of a Uniden scanner,

you will need to have a computer with

at least two serial ports. One serial

port will be connected to the Pro-96 to

read the control channel data, the

second serial port will be connected to

the Uniden scanner to be used to

monitor the voice transmissions.

Control Port:

This port is used to control the Uniden scanner. This port may not be set to the

same port as the one being used to collect data from the Pro-96. Setting this port

to the same port as the Pro-96 will automatically disable the Uniden control

option.

Port Speed:

Uniden scanners may use a variety of port speeds. The scanner automatically

detects the speed of the port based on the initial commands sent to it. If your

Uniden scanner is having problems accepting control commands from

Pro96Com, try changing the port speed to a lower speed until you get good

results.

Scan Mode:

You may optionally have Pro96Com place the Uniden scanner in scan mode

whenever there are no active TalkGroups on the system being monitored.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 28 29

Žádné komentáře

Uniden BC250D Technické informace Strana 19